Why does GBC Ultima 65 film curl opposite directions?
If the film curls in opposite directions on the edges as it exits the back of your GBC Laminator, it may be because the film supplies were not properly matched during the manufacturing process. Try swapping the top and bottom rolls.
How to prevent media curl after GBC lamination?
If your media has curl after lamination with your GBC laminator, it could be because the film rolls have too much tension or drag on them. Clean the film saddles with a damp, lint-free cloth. Also, ensure the film rolls are approximately the same size. You can also try swapping the top and bottom rolls to change the tension.
Highlights critical warnings such as avoiding cutting hazards, electrical shock, burns, and unauthorized servicing of the machine.
Lists general safety precautions for operating the laminator, including keeping hands away from rollers and avoiding unstable surfaces.
Details electrical safety requirements, including voltage compatibility, unplugging, cord condition, and avoiding extension cords.
Provides warnings and conditions under which to contact GBC Technical Service for machine issues.
Details guidelines for placing the laminator, connecting power, and positioning for film exit.
Lists crucial warnings regarding cleaning agents, flammable items, liquids, and specific materials that can damage the rollers.
Provides step-by-step instructions for loading both EZ Load and Standard film rolls into the laminator.
Details the process of loading standard film onto the film shaft before inserting it into the saddles.
Explains the procedure to clear a film jam by reversing the rollers and re-threading the film.
Lists common symptoms, possible causes, and corrective actions for issues like machine not turning on or film not sticking.
To Next Page
General
