What to do if GE HEALTHCARE B20 Medical Equipment displays 'Check sample gas out'?
If the GE HEALTHCARE Medical Equipment displays 'Check sample gas out', the sample gas outlet is blocked. Remove the blockage from the sample gas outlet.
How to fix 'Leads off' error on GE HEALTHCARE B20 Medical Equipment?
If the GE HEALTHCARE Medical Equipment displays 'Leads off', it means the ECG cable is disconnected. Check the ECG cable and its connections to ensure they are properly attached.
What to do if GE HEALTHCARE Medical Equipment displays 'Check SpO2 probe'?
If the GE HEALTHCARE Medical Equipment displays 'Check SpO2 probe', it indicates that there is no detectable SpO2 signal, the sensor is faulty, or it is detached from the patient. You should check the sensor and its connections.
What to do if GE HEALTHCARE Medical Equipment displays 'Long measurement time' on GE HEALTHCARE Medical Equipment?
If GE HEALTHCARE Medical Equipment displays 'Long measurement time', reduce the patient’s motion.
What does 'No battery backup' mean on GE HEALTHCARE B20?
If the GE HEALTHCARE Medical Equipment displays 'No battery backup', and the monitor has the battery option, insert a battery.
What to do if GE HEALTHCARE B20 displays 'Check D-fend'?
If GE HEALTHCARE Medical Equipment displays 'Check D-fend', it may be because the water trap is not attached. Check that the water trap is properly attached to the module.
What to do if GE HEALTHCARE Medical Equipment displays 'Incompatible SpO2 Probe'?
If the GE HEALTHCARE Medical Equipment displays 'Incompatible SpO2 Probe', it means the SpO2 sensor is not compatible. Replace the sensor.
What does 'Saving to Network' mean on GE HEALTHCARE B20 Medical Equipment?
If the GE HEALTHCARE Medical Equipment displays 'Saving to Network', wait and do not interrupt the process.
What to do if GE HEALTHCARE B20 Medical Equipment displays 'Tachy'?
If the GE HEALTHCARE Medical Equipment displays 'Tachy', immediately check the patient status.
What to do if GE HEALTHCARE B20 Medical Equipment displays 'Art disconnect/ABP disconnect/UAC disconnect'?
If the GE HEALTHCARE Medical Equipment displays 'Art disconnect/ABP disconnect/UAC disconnect', check the Art/ABP/UAC line and the patient status.
General| Brand | GE HEALTHCARE |
|---|---|
| Model | B20 |
| Category | Medical Equipment |
| Language | English |
Covers the procedures for starting and ending patient monitoring sessions safely.
Details the process of admitting a new patient and entering necessary demographic data.
Covers adjustments for alarm limits, volume, tones, and audio settings for customization.
Lists common error messages, their explanations, and recommended actions.
Addresses common issues with ECG signal quality, detection, and artifacts.
Provides troubleshooting steps for NIBP measurement issues and unstable values.
Guides on adjusting high and low heart rate alarm limits for patient monitoring.
Guides on connecting the SpO2 sensor to the patient and module correctly.
Guides on connecting the transducer, tubing, and catheter for IBP measurement.
Explains the importance and procedure for zeroing IBP transducers for accurate measurements.
Guides on adjusting IBP alarm sources and limits via the Alarms Setup menu.
Lists warnings and cautions related to temperature measurement and electrosurgery use.
Guides patient connections for E-miniC and CARESCAPE modules with airway adapters.
Lists warnings and cautions for Entropy measurement, including defibrillator precautions.
Guides on preparing the patient and placing Entropy sensors on the forehead.
To Next Page
