How to resolve 'Weak pulsation' on GE HEALTHCARE B20?
If GE HEALTHCARE Medical Equipment displays 'Weak pulsation', check the patient status, the NIBP cuff position and attachments, and ensure the cuff is not damaged. You may also need to repeat the measurement.
What to do if GE HEALTHCARE B20 shows Apnea/No breath?
If the GE HEALTHCARE Medical Equipment displays 'Apnea/No breath', immediately check the patient status and the ventilator and breathing circuit to ensure proper function and connection.
What does 'Replace Battery A Replace Battery B' mean on GE HEALTHCARE B20?
If the GE HEALTHCARE Medical Equipment displays 'Replace Battery A Replace Battery B', it means there is hardly any charge left in one of the batteries, so replace the battery as soon as possible.
What to do if GE HEALTHCARE B20 displays 'Battery empty, Battery low'?
If the GE HEALTHCARE Medical Equipment displays 'Battery empty, Battery low', replace the battery or connect the monitor to a power outlet.
What to do if GE HEALTHCARE B20 displays 'Check D-fend'?
If GE HEALTHCARE Medical Equipment displays 'Check D-fend', it may be because the water trap is not attached. Check that the water trap is properly attached to the module.
What to do if GE HEALTHCARE Medical Equipment displays 'Incompatible SpO2 Probe'?
If the GE HEALTHCARE Medical Equipment displays 'Incompatible SpO2 Probe', it means the SpO2 sensor is not compatible. Replace the sensor.
How to resolve 'Entropy sensor off' on GE HEALTHCARE B20 Medical Equipment?
If GE HEALTHCARE Medical Equipment displays 'Entropy sensor off', it means the Entropy sensor is connected to the cable but not attached to the patient. Check that the sensor is properly attached to the patient.
How to resolve 'Entropy cable off' on GE HEALTHCARE Medical Equipment?
If GE HEALTHCARE Medical Equipment displays 'Entropy cable off', it means the Entropy sensor cable is not connected to the Entropy module. Connect the Entropy cable to the Entropy module.
How to resolve 'SpO2 probe off' on GE HEALTHCARE B20?
If GE HEALTHCARE Medical Equipment displays 'SpO2 probe off', it may be because the finger or ear lobe is too thin, or the sensor halves are not aligned. Check the connection between the sensor and the patient and consider replacing the sensor.
What to do if GE HEALTHCARE B20 Medical Equipment displays 'No SpO2 pulse'?
If the GE HEALTHCARE Medical Equipment displays 'No SpO2 pulse', try other measurement sites, as the pulse signal may be poor.
General| Brand | GE HEALTHCARE |
|---|---|
| Model | B20 |
| Category | Medical Equipment |
| Language | English |
Covers the procedures for starting and ending patient monitoring sessions safely.
Details the process of admitting a new patient and entering necessary demographic data.
Covers adjustments for alarm limits, volume, tones, and audio settings for customization.
Lists common error messages, their explanations, and recommended actions.
Addresses common issues with ECG signal quality, detection, and artifacts.
Provides troubleshooting steps for NIBP measurement issues and unstable values.
Guides on adjusting high and low heart rate alarm limits for patient monitoring.
Guides on connecting the SpO2 sensor to the patient and module correctly.
Guides on connecting the transducer, tubing, and catheter for IBP measurement.
Explains the importance and procedure for zeroing IBP transducers for accurate measurements.
Guides on adjusting IBP alarm sources and limits via the Alarms Setup menu.
Lists warnings and cautions related to temperature measurement and electrosurgery use.
Guides patient connections for E-miniC and CARESCAPE modules with airway adapters.
Lists warnings and cautions for Entropy measurement, including defibrillator precautions.
Guides on preparing the patient and placing Entropy sensors on the forehead.
To Next Page
