GE 20309 - Setting Mode-Specific Volume

13
Using Your Remote, cont.
Setting any Mode to use its own Volume/Mute Control
This routine can set any Mode to use only its own Volume/Mute
control. Note - If your chosen Mode has no Volume/Mute functions
of its own then the Volume/Mute buttons will do nothing.
1. Press and hold the SETUP button until the red indicator
turns on, then release the button.
2. Press and hold the MUTE button until the red indicator
blinks off, then release the button.
3. Press and release the desired Mode button (TV, VCR,
etc.), the red indicator blinks then stays on.
4. Press and release the VOLUME- (Down) button, the
red indicator blinks then stays on.
5. Press and release the MUTE button and the red
indicator turns off.
Your chosen Mode will now use its own Volume/Mute
control.