9
If your device does not respond after you have tried all the codes
for your brand, or if your brand is not listed, try searching for your
code by following these steps.
1. Manually turn on the device (TV, VCR, etc.) to be
controlled.
2. Press and hold the SETUP button until the red indicator
stays on, then release the SETUP button.
3. Press and quickly release the desired mode button
(TV, VCR, etc.). The red indicator blinks off once.
4. Press the ON•OFF button repeatedly (up to 300
times) until the device to be controlled turns off.
The red indicator blinks off with each button press.
5. Press and release ENTER to install the code.
Most users will store VCR codes under the VCR button,
Cable codes under CABLE, etc. If (for example) you want to store a
VCR code under CABLE, first follow the procedure for Direct Code
Entry (page 8) and press CABLE in step 2 of Direct Code Entry, then
enter ANY VCR code in step 3 of Direct Code Entry. Then follow the
steps above for Code Search.
Note: If the device does not have a CHANNEL UP button, use PLAY
(VCR only) or POWER instead. Code Search starts from the currently
stored 4 digit number under that mode. Sometimes the first code
that “works” with your device may only allow limited functionality
(e.g. the MENU button might not work). There may be a code that
performs more functions. Continue the code search process until
the best code is found.
Code Search
To Next Page
Loading...
Need help?
General
