6
Device Device stored Code
TV TV
DVD
CBL/SAT
VCR/AUX
Direct Code Entry
1. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
2. Press and release the desired device button (TV,
DVR, etc.). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables (on
separate sheet). Note: after a valid code entry, the
red indicator turns off. For an invalid
code, the red indicator flashes.
4. With your device on, press ON•OFF.
If the device turns off, no further
programming is required. Note: If
some buttons do not operate your
equipment, try one of the other codes
for your brand.
Write your codes down here for easy reference later.
To Next Page
Loading...
