8
Most users will store VCR codes under the VCR button,
DVD codes under DVD, etc. If (for example) you want
to store a VCR code under DVD, first follow the proce-
dure for Direct Code Entry (previous page), and press
DVD in step 2 of Direct Code Entry, then enter ANY
VCR code in step 3 of Direct Code Entry. Then follow
the steps for Code Search on the previous page. Note:
If the device does not have a CHANNEL UP button,
use PLAY (VCR only) or ON-OFF instead. Code Search
starts from the currently stored 4-digit number under
that mode.
Code Search, cont.
Code Identification Feature
The Code Identification Feature allows you to identify
the four digit library code stored under your device
key. For example, if you want to find out what 4-digit
code is stored under your TV device key, follow the six
steps below:
1. Press and hold the SETUP button until the red
indicator stays on. Release the SETUP button.
2. Press and release the desired mode button (TV,
VCR, etc.). The red indicator blinks, then stays lit.
3. Press and release the SETUP button. The red
indicator blinks off.
4. To find the first digit for the code stored under the
mode key pressed in step 2, press each numeric
key from 0-9 in turn. When the red indicator blinks
off the number you pressed is the first digit for the
code you are searching for.
5. To find the second digit, repeat step 4. This time
when the red indicator blinks off this is the second
digit.
6. Repeat step 4 to find the third and fourth digits.
To Next Page
Loading...
