GE 869 - Page 117

CHAPTER 3: INTERFACES SOFTWARE INTERFACE
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL 3–39
The following figure shows the objects that are available for design in the SLD Configurator
and their maximum usage limits [X]. The maximum limit reflects the maximum possible
order code.
Figure 3-19: SLD Configurator Component Library
Control Objects
The control objects consist of selectable breakers and disconnect switches. The following
figure shows the different symbols in the GE Standard style and IEC style. If the switching
element is tagged, blocked, or bypassed, indicators with the letters “T”, “B”, and “By”
appear on the lower right corner of the element. Additionally, the breaker/switch name is
displayed on top of the object.
In 869 , a contactor can be used instead of a breaker by selecting it as the switching device
from the motor setup settings. While designing the single line diagram through the SLD
Configurator, the breaker and contactors will be available depending on the switching
device selection in motor setup.
NOTE
NOTE:
The displayed breaker name is configured in the setpoint Setpoints > System > Breakers >
Breaker[X] > Name. This setpoint has a 13-character limit. The name should be kept to a
minimum so that it appears properly on the SLD.
NOTE
NOTE:
The displayed breaker or contactor name comes from their respective system setup
settings. This setpoint has a 13-character limit. The name should be kept to a minimum so
that it appears properly on the SLD.