GE 869 - B.APPENDIX B Warranty; Major Updates

B–2 869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
REVISION HISTORY CHAPTER B: APPENDIX B
Major Updates
Table 2: Major Updates for 869-A8
Chapter CHANGES
cover
Manual revision number from A7 to A8, and Product version revision from
1.7x to 1.8x
3
Revised Single Line Diagram section, see Interfaces > Front Panel Interface
> Graphical Display Pages
3
Added new SLD Configurator section see Interfaces> Software Interface >
Advanced EnerVista 8 Series Setup Software Features
4
Added new Tab Pushbuttons section to Setpoints > Device > Front Panel >
Tab Pushbuttons
4
Added new Annunciator with Panel section to Setpoints > Device > Front
Panel > Annunciator
4
Added new Switches section (for disconnect switch setup) to Setpoints >
System > Switches
4
Revised Breaker logic diagram to 892740A2.cdr to update settings for
contact input 52a, 52b and remove the breaker disconnected
dependencies
4
Revised Undercurrent logic diagram to 894205A1.cdr to add setting for
signal input
4 Added new SOTF section to Setpoints > Protection
4
Revised Negative Sequence Directional OC logic diagram to 894204A1.cdr
to add setting for signal input
4
Revised Broken Conductor logic diagram to 894043A2.cdr to add setting for
signal input
4
Revised Load Encroachment logic diagram to 894044A2.cdr to add settings
for CT input and VT inputs
4
Revised Thermal Overload logic diagram to 894045A3.cdr to add setting for
signal input
4
Added new Timed Undervoltage section to Setpoints > Protection > Voltage
Elements
4
Added new UV Reactive Power section to Setpoints > Protection > Voltage
Elements
4
Revised Neutral Overvoltage logic diagram to 894050A2.cdr to add setting
for signal input
4
Revised Negative Sequence OV logic diagram to 894051A2.cdr to add
setting for signal input
4 Added new Admittance section to Setpoints > Protection
4
Revised Wattmetric Ground Fault logic diagram to 894053A2.cdr to add
settings for CT and VT inputs
4 Added new ESA section to Setpoints > Monitoring
4
Revised Pulsed Outputs logic diagram to 894064A2.cdr to add setting for
signal input
4 Added new Local Control Mode section, see Setpoints > Control
4 Added new Breaker Control section, see Setpoints > Control
4
Added new Switch Control (for disconnect switch control) section to
Setpoints > Control > Switch Control