GE 869 - Results Window

3–54 869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
SOFTWARE INTERFACE CHAPTER 3: INTERFACES
Results Window The following figure shows an example conversion summary results window.
Figure 3-27: Results Window
The results window has the following columns:
• Name: the same tree structure as in the offline window, but with status icons
NOTE
NOTE:
Settings in the results window are linked to setting screens. This means the user can click in
the results window to navigate to the corresponding 8 Series settings window.
• Value: the converted value for the 8 Series settings file
• Original Name: setting name of the input file
• Original Value: setting value of the input file
CAUTION:
All other settings available (not shown in the conversion report) in the 8 Series file are
set to default and must be verified by the user before putting the relay into service.
NOTE
NOTE:
Custom curves from 469 cannot be converted to 869 although they appear in the
conversion report. Although settings show successful conversion, the user must still verify
the settings before putting the relay in service.
Status Icons
The status icon shows the conversion results:
Manual configuration required
Successful conversion
Value is not supported
Print Report If desired, the conversion summary report can be printed using the File/Print
command in the EnerVista taskbar or it can be printed from the “GUI” print button.
NOTE
NOTE:
Although the report shows successful conversion (green checkbox), the settings must still
be verified before putting the relay in service.