GE AF-60 LP - Page 71

Parameter Number Parameter Description Default Value 2 Setup Change During Operation Conversion Index Type 2 - 00 DC Hold Current 50% All set-ups TRUE 0 Uint16
2 - 01 DC Brake Current 50% All set-ups TRUE 0 Uint16
2 - 02 DC Braking Time 10 s All set-ups TRUE -1 Uint16
2 - 04 DC Brake Cut In Speed 0 Hz All set-ups TRUE -1 Uint16
2 - 10 Brake Function [0] Off All set-ups TRUE - Uint8
2 - 11 Brake Resistor (ohm) All set-ups TRUE 0 Uint16
2 - 16 AC Brake, Max current 100% All set-ups TRUE 0 Uint16
2 - 17 Over-voltage Control [0] Disabled All set-ups TRUE - Uint8
2 - 20 Release Brake Current 0 A All set-ups TRUE -2 Uint32
2 - 22 Activate Brake Speed [Hz] 0 Hz All set-ups TRUE -1 Uint16
5.2.7. 2-** Brakes
AF-60 LP™ Micro Drive Programming Guide
70
5