About the controls on the air conditioner-Cool Only Models
[] On
[] Off
Delay Hrs
[] Cool
[] Fan
[] Hi
[] Med
[] Low
[] []
Temp
imDi
Air Conditioner Controls
Lights beside the touch pads on the air conditioner
control panel indicate the selected settings.
Controls
Power
Remote Control
Power On/Off
Turns air conditioner on and off.
Display
Displays the temperature setting. Displays
hours when setting the timer.
Mode
On the remote control, use to set the air
conditioner to Coolor Fan mode.
On the air conditioner controls, use to set
Coolor Fan mode at High, Medor Lowfan
speed. Indicator lights on the air conditioner
controls will show the mode and fan speed
selected.
Temp Increase +/Decrease - Pads
Use to set temperature when in COOL mode.
Fan Speeds (Remote control on/y)
Use to set the fan speed at Low, Medor
High,
Delay Firs
On--When the air conditioner is off, it can
be set to automatically turn on in half an
hour to 24 hours at its previous setting. Each
touch will set the time in half hours up to 10
and then in hours up to 24.
To cancel the Delay Timer, press the On pad until
"CL" appears. Then wait until the display turns off.
Off--When the air conditioner ison, it can be set to
automatically turn off in half an hour to 24 hours.
Each touch will set the time in half hours up to 10
and then in hours up to 24.
To cancel the Delay Timer, press the Offpad until
"CL" appears and wait for the set temperature to
be displayed. The unit will now resume normal
operation.
Reset Filter
LEDwill turn on when fan has accumulated 250
hours of run time as a reminder to clean filter.
Press Reset Filter to turn off the LED and reset the
accumulated run time.
Remote Control Signal Receiver
NOTE'When the air conditioner is turned on, it will
automatically start in the setting last used.
Remote Control
m
m
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
The remote control signal has a range of up to
21 feet.
m Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
m Make sure batteries are fresh and installed
correctly--see the Care and Cleaning section.
To Next Page
Loading...
