GEAppliances.com
Cool Mode
Remote Control
1,PressCool pad,
2,PressLow, Medor High pads to set desired fan speed,
3,Pressthe Increase +/Decrease- pads to set
the desired temperature 60°Fto 85°Fin 1°F
increments,
Control Panel
1,Pressthe Mode pad until the Coolindicator light is lit
and the Low, Medor High indicator light is litfor the
desired fan speed,
2,Pressthe Increase +/Decrease - pads to setthe
desired temperature 60°Fto 85°F in 1°Fincrements,
A thermostat is used to maintain the room temperature,
The compressor will cycle on and off to keep the room
at the set level of comfort, Setthe thermostat at a lower
number and the indoor air will become cooler,
Set the thermostat at a higher number and the indoor air
will become warmer,
NOTE."If the air conditioner isoff and isthen turned on
while set to Cool, it will take approximately 3 minutes
for the compressor to start and cooling to begin,
Cooling Descriptions
For Normal Cooling-Select the Cool mode and High or
Medfan with a middle settemperature.
For tfeximum Cooling-Select the Cool mode
and HIGHfan with a lower set temperature.
For Quieter and Nighttime Cooling-Select the Cool
mode and Lowfan with a middle set temperature.
NOTE."If you switch from a Cool setting to Off or to
a fan setting, wait at least 3 minutes before switching
back to a Cool setting.
FAN MODE
Usethe Fan mode to provide air circulation and filtering
without cooling, Sincefan-only settings do not provide
cooling, a temperature setting will not bedisplayed,
Remote Control
PressFan pad, PressLow, Medor High pads to set
desired fan speed,
Control Panel
Pressthe Mode pad until the Fan indicator light is lit
and the Low, Medor High indicator light is lit for the
desired fan speed,
To Next Page
Loading...
