GE b30 - Page 355

CHAPTER 3: IEC 61850 COMMUNICATION MODEL IMPLEMENTATION CONFORMANCE STATEMENT (MICS)
UR FAMILY – COMMUNICATIONS GUIDE 3-117
3
3.5.3.2 8-bit switch (Sw8bit)
This element is instantiated in the following products: C30, F35, N60.
Table 3-136: 8-bit switch data objects
stVal ENUMERATED ST LLN0.Beh.stVal of the Master
logical device
R
Health ENS Only instantiated in the Master logical
device
R
stVal ENUMERATED ST LPHD1.PhyHealth.stVal R
On SPS Only instantiated in the Master logical
device
R
stVal BOOLEAN ST R
Off SPS Only instantiated in the Master logical
device
R
stVal BOOLEAN ST R
Zero MV Only instantiated in the Master logical
device
R
mag AnalogueValue MX R
mag.f FLOAT32 0.0 R
Mod ENC Only instantiated in the Master logical
device
R/Ctrl
ctlVal ENUMERATED R
stVal ENUMERATED ST R
ctlModel CtlModels CF LLN0.Mod.ctlModel 2, the code for SBO control with normal
security according to IEC 61850-7-2.
R/C
sboTimeout INT32U CF 30000 R
sboClass SboClasses CF 0 (operate-once) R
operTimeout INT32U CF 0 R
GrRef ORG Reference to root logical device R
setSrcRef ObjectReference SP For communications, mapped to
Master ldName if not empty,
otherwise to the concatenation
of the IED name and “Master”.
For SCL, mapped to the
concatenation of the IED name
and “Master”.
reference to the data attribute to input R
MltLev SPG Instantiated only in the Master logical
device
R
setVal BOOLEAN SP R
<TTΣDataS
et##>
DATA-SET R
DSMemberRef[η] ObjectReference DataSet Member η R/C
LNName: Sw8BitGAPC# LDevice inst: Ctrl UR element: 8-Bit Switch #
data obj. data attribute Type FC UR Name Description R/W/C
IndY SPS 8BIT SWITCH # BIT Θ operand value R
stVal BOOLEAN ST 8BIT SWITCH # BIT Θ R
InRef1Θ ORG 8BIT SW # ARG AΘ setting. R
setSrcRef ObjectReference SP 8BIT SW # ARG AΘ setting reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef2Θ ORG 8BIT SW # ARG BΘ setting. R
setSrcRef ObjectReference SP 8BIT SW # ARG BΘ setting reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef01 ORG 8BIT SW # CONTROL setting. R
setSrcRef ObjectReference SP 8BIT SW # CONTROL setting reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
LNName: LLN0 LDevice inst: Ctrl UR element: Nameplate information for the logical nodes
data obj. data attribute Type FC UR Name Description R/W/C