Installation
Instructions
Refrigerator
GE card M models
Questions? Call 800.GE.CARES(800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Built-in style models (model PYE,CYE,and PWE) are
top heavy, especially with any doors open. These
models must be secured with the anti-tip floor
bracket to prevent tipping forward, which could
result in death or serious injury. Read and follow
the entire installation instructions for installing the
anti-tip floor bracket packed with your refrigerator.
• IMPORTANT-ObserveaUgoverning codes
and ordinances. Savethese instructions for local
inspector's use,
• Note to Installer - Besure to leave these instructions with
the Consumer.
• Note to Consumer- Keepthese instructionsfor future
reference.
• Skill level- Installation of this appliance requires basic
mechanical skills.
• Completion time - Refrigerator Installation can vary
Water Line Installation 30 minutes
• Properinstallation isthe responsibilityof the installer.
• Product failure due to improper installation is not covered
under the Warranty.
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorway, the
refrigerator door and freezer drawer can be removed.
• To remove the refrigerator door, seethe Installingthe
Refrigeratorsection.
• To remove the freezer drawer, see the Removingthe
FreezerDrawer section.
WATER SUPPLY TO THE ICE MAKER AND DISPENSER
If the refrigerator has an ice maker, it will have to be
connected to a coldwater line.AGEwater supply
kit (containing tubing, shutoff valve, fittings and
instructions)is availableat extra cost from your dealer,
byvisiting our website at GEApp/iances.com(inCanada
at www.GEApp!iances.ca)or from Partsand Accessories,
800.626.2002(inCanada 1.800.661.1616).
21
TOOLS YOU MAY NEED
Adjustable Wrench
3/,_"SocketRatchet/Driver
1/4"OuterDiameter
Compression Nut
and Ferrule(sleeve)
Phillips-Head Screwdriver
1/8", 3/32", 1/4" & 5/32"
Allen Wrenches
Flat-Head Screwdriver
1/8" Drill Bit and
Electric or Hand Drill
Tape Measure
Pencil 1/4" Nut Driver
Pliers
Level
Torx T20,T25
To Next Page
Loading...
Need help?
General
