GE Concord 4 User Manual

GE Concord 4 Quick User Guide Page 4
To Delete a User Access Code:
1. Enter programming menu by pressing 9 + System Menu Code.
2. Press B button (down arrow to right of LCD display) until display reads User Codes, then
press #.
3. Display will read Regular User Codes. Press #.
4. Display will read Reg Code 01 or Code 000. Press B button until the display shows the
user code you want to delete, and then press #.
5. Enter the System Master Code used in Step 1, then press #.
6. Display appears as User 01 **** or Reg 01.
7. Press * + B button to move to the next user code or press * + 00 + # to exit programming.
Keypad Panic Buttons
Press and hold POLICE button (blue shield) for 2 seconds. Siren will sound. If monitored, emergency
service will be sent. Enter code to stop siren when emergency is over.
Press and hold MEDICAL button (green cross) for 2 seconds. Siren will not sound. If monitored,
emergency service will be sent. Enter code to cancel medical panic when emergency is over.
Press and hold FIRE button (red flame) for 2 seconds. Siren will sound. If monitored, emergency
service will be sent. Enter code to stop siren when emergency is over.
Time Programming (System Clock)
1. Press 9 + Master CODE.
2. Press 020
3. Enter the correct time in 24-hour format. Press #.
4. Press * + 00 + # to exit.
Date Programming (System Date)
1. Press 9 + Master CODE.
2. Press 021.
3. Enter the current date as six digits (mm/dd/yy). Press #.
4. Press * + 00 + # to exit.
Chime Mode
Your system can alert you to the opening of a door while it is disarmed by using the Chime feature.
When activated, two beeps will sound at the keypad whenever a door or window is opened.
To enable or disable the Chime feature, Press 7 + 1 – chime turns on/off.
Quick System Status
Checking the system status means finding out about the current condition of your system.
1. Press *.
2. The keypad will display the trouble on your system.
Full Status
Checking the system status means finding out about the current condition of your system.
1. Press * + *.
2. The keypad will display the trouble on your system.

GE Concord 4 Specifications

General

Zones	96
Partitions	6
User Codes	230
Power Supply	16.5 VAC, 40 VA
Wireless Compatibility	Compatible with GE wireless sensors
Keypads	Up to 8
Outputs	2 onboard, expandable
Event Log	512 events
Backup Battery	12VDC, 7AH
Communication	Phone line, optional cellular or IP