Need help?Do you have a question about the GE NETWORX NX-108E and is the answer not in the manual?
General| Brand | GE |
|---|---|
| Model | NETWORX NX-108E |
| Category | Security System |
| Language | English |
Indicates if the system is armed, disarmed, or has a previous alarm.
Indicates if any zone has been bypassed, showing bypassed zones illuminated.
Flashes during abort delay; indicates communication stop or cancel report.
Indicates if the chime feature is active for entry/exit doors.
On during exit delay; flashes rapidly during the last 10 seconds.
Steady for fire alarm, flashing rapidly for fire system trouble.
Indicates no entry/exit delay; triggers immediate alarm if door opened.
On for AC power; flashes for low battery condition.
On when system is ready to arm; flashes for force arm.
On when interior zones are bypassed for stay mode.
Activates fire alarm and sends emergency report to monitoring center.
Activates auxiliary alarm and sends emergency report to monitoring center.
Sounds local alarm or sends silent/audible report to monitoring center.
Steps to arm the system when no one is present.
Steps to arm the system for protection while inside.
Procedure to disarm the security system after an entry delay.
How to enable or disable the chime feature for entry/exit doors.
Procedure to assign different authority levels to user codes.
Instructions for adjusting the keypad's sounder tone.
How to display zones that caused the last alarm or were bypassed.
To Next Page
