Need help?Do you have a question about the GE NX-10 and is the answer not in the manual?
General| Brand | GE |
|---|---|
| Model | NX-10 |
| Category | Security System |
| Language | English |
Keys for Arm Away, Arm Stay, Disarm, and Night Mode operations.
Keys for Bypass Zone and Chime mode control.
Programmable keys F1, F2, F8 for installer-defined functions.
Keys for menu scrolling, selection, confirmation, and data input/editing.
Icons for Power, Bypass, Armed Status, Away, Stay/Night Mode.
Icons for Fire, Alarm, Trouble, Service, Ready to Arm.
Icon for Chime mode, Low Battery indicator.
Access limited menu options without a user code.
Modify keypad display language via menu options.
Perform keypad functions using your user code.
Move through menu options and lists of entries.
Safely exit the menu system using specific key presses.
Enter secured partition, delay starts, sounds continuously.
Activates pulsed siren, keypad beep, and reports to central station.
Sends a report to the central station.
Activates continuous siren, rapid keypad beep, and reports.
Assign user rights for functions like Authority, Control Outputs.
Assign partitions a user can access, manage user permissions.
Modify the keypad's display language.
Control the loudness of the keypad sounder.
Initiate a call to the installer's computer for data transfer.
Allow the control panel to receive data from the installer's computer.
Excessive current drawn from an output.
Connection to the control panel's siren is broken.
Interference with the control panel casing.
Phone line connected to the control panel is not working.
Control panel failed to send message to central station.
Procedure for replacing the wireless keypad backlighting batteries.
Procedure for master user to replace operating batteries.
To Next Page
