GE NX-10

NX-10 User Manual 26
Setting up light control
2. Scroll to Light Control and press OK.
3. A list of all the configurable switches in your system is displayed. Each
switch has a unique identifying number.
4. Navigate with the  keys to the relevant switch and press OK.
5. Scroll to Module Number and select the control that is attached to the
selected switch.
6. Scroll to House Code and select your house code with the  keys.
House code is always a single letter. Ensure that you turn on the
switches in the correct house!
1. Press OK and enter your user code.
The light control system allows you to turn on devices in your house from your keypad. For example, you can turn on all the downstairs
lights in your house. To do this, you attach a programmable control to each light switch. You then use the keypad to assign the control to
the switch and specify the house that contains the switches.

OK
User Menu
+Light Control
Light Control
+Device 1

OK
Device 1
Module Number
Device 1
House Code
........
........
........
........
........
........