NX-10 User Manual 20
Changing user rights
2. Select the user group. Navigate with the keys to the relevant user
number and press OK.
To select the functions a user can perform
• Navigate with the keys to Authority and press OK. A list of user
rights is displayed. See the glossary for more information.
• Scroll through the list of rights and press OK to assign rights to the
selected user. Select NO to return to the selected user number.
To select the partitions a user can access
• Navigate with the keys to Partitions and press OK. The partitions
the user can access are listed.
• Press a partition number to assign it to the selected user. Press the
number again to unassign the partition. Press OK.
1. A list of all users is displayed. They are displayed in groups of 10.
You can set a user’s rights to arm, disarm, control outputs, send reports and bypass zones. You can also set the user’s code to be a master
code and specify the partitions the user can access. To do this, press OK and enter a master user code. In a new system the User 1 is the
master user by default. Navigate with the
keys to Users and press OK.
Users 1 - 10
+(1) John Murphy
OK
OK
NO
OK
Partitions
1 _ 3 4
........
........
........
........
........
........
Important: When Control Outputs authority is selected for the user, this
user loses his/her master user rights, and is not able to edit any user
information! Remember to set this authority for regular user codes only!
To Next Page
Loading...
Need help?
General
