7. Turn the door chime on or off:
a. Press CHIME (7) + 1.
b. You will hear three beeps if enabled, one beep if disabled.
c. 8. Check system status:
d. Press * for short status
e. Press * * for long status
f. To change your four-digit Master Code:
g. Press 9 then the four digit master code
h. It will say TIME and DATE
i. Press the down arrow or 8 button until it says USER CODES
j. Press#
k. Press the down arrow or 8 button until it says SYSTEM MASTER CODE
l. Press#
m. Enter the new four digit MASTER CODE
n. Press#
o. Press * until it says USER CODES again
p. Press the up arrow or A button until it says EXIT PROGRAMMING READY
q. Press#
The manufacturer of your security system recommends that you test it weekly to
ensure that the system is communicating fully with the Monitoring Station in the event
that an alarm is triggered. If for any reason you feel your security system is not
functioning properly, do not hesitate to call our office at 770-963-0305. We have
technicians available to assist you twenty-four hours per day.
To Previous Page
Loading...
Need help?
General
