GE Supra KeySafe User Manual

How to Set the Code
Once you have opened your GE KeySafe™ from its packaging press
the OPEN button down and free the lid from the vault.
If this is not possible press the CLEAR
button down first - you will find this
below the OPEN button.
With the lid in your hand you will notice the digits
1 to 5 down the left and 6 to
ZERO down the right.
There is NO pre-set code and
you will notice the OPEN button
moves freely.
Turn the lid over in your hand and remove the
white card. The white card is utilized to assist
with the setting of your code and should
not be disguarded.
You will notice 10 numbered
screws with an arrow on each
of them.
All arrows will be set to the OFF
position.
Using the screwdriver tip on the white card
push and turn the desired numbers
within your code 180 degrees.
1
2
3
4
5
6
7
8
9
0
12
SET ON
345
67890
SET OFF
180°
Supra UK Limited, 24 The Furlong, Berry Hill Industrial Estate, Droitwich Spa, Worcestershire, WR9 9AH
Tel: 08700 539723 Fax: 01905 797773 Email: sales@keysafe.co.uk
Web: www.keysafe.co.uk

GE Supra KeySafe Specifications

General

Type	Key Safe
Material	Metal
Weight	1.5 lbs
Weather Resistant	Yes
Battery Required	No
Model	Supra
Mounting	Wall
Lock Type	Combination lock
Access Method	Push-button combination

Summary

Setting the KeySafe Code

Opening and Initial Inspection

Open the KeySafe, identify digit dials, and check the OPEN button's initial state.

Code Setting Procedure

Use the white card and screwdriver to turn numbered screws to set your desired code.

Completing the Code Setup

Code Verification and Final Steps

Verify the set code, attach the key, and secure the lid onto the vault.

Mistake Correction and Lid Securing

Use the CLEAR button for errors and press the OPEN button to secure the lid.