25
TROUBLESHOOTING GUIDE
Symptom (Alarm) Possible Cause
Remedies
Switch on, unit not
operating
Pressurized storage
switch or float switch
has cut power to the
machine
Check the permeate backpressure
or position of float in the storage
tank.
Thermal overload in
motor has tripped.
Allow the machine to cool; check the
feed water supply and/or amp draw
of the motor.
No power to machine. Check the fuses or circuit breakers;
measure the voltage.
Deluxe (DLX) Electrical
machine shutdown
Alarm condition has
turned off machine.
Restart the machine by pushing the
alarm bypass. Check all possible
alarm conditions; inlet pressure and
push alarm reset switch.
Motor and/or pump
not operating properly.
See the pump instructions. Contact
GE for repair of replacement.
Timer relay
defective/burned out
Replace the relay.
Motor starter
overloaded, heater
tripped.
Turn the switch off; let the heater(s)
cool.
To Next Page
Loading...
Need help?
General
