GE E4H-16K - User Manual

52 pages

Save Page as PDF

To Next Page

OPERATIONS AND MAINTENANCE

E4H Series Water Purification

16,000 GPD to 43,200 G

60.6 m

/day to 163.5

NOTICE

The enclosed materials are considered proprietary property of GE Water & Process Technologies. No assignments, either implied or expressed, of

intellectual property rights, data, know-how, trade secrets or licenses of use thereof are given. All information is provided exclusively for the addressee for

the purposes of evaluation and is not to be reproduced or divulged to other parties, nor used for manufacture or other means, or to authorize any of the

above, without the express written consent of GE Water & Process Technologies. The acceptance of this document will be construed as an acceptance of

the foregoing conditions. * Trademark of General Electric Company; may be registered in one or more countries.

Main Page

Questions and Answers

A
Alexander GreenAug 1, 2025
Why does my GE Water Filtration Systems have low operating pressure?
- G
  grobinsonAug 1, 2025
  If your GE Water Filtration System has low operating pressure, it could be due to high flow rates. Try closing the concentrate bypass valve and checking the permeate and concentrate flow rates, adjusting them if necessary. Note that excessive permeate flow may indicate improper interconnector installation. Also, inspect and clean the pump discharge screen, as it may have low primary pressure. Dirty or fouled membranes (low final pressure) may also cause this problem, requiring you to clean the membranes. Warm operating conditions should be corrected. If you have a 3-phase power system, check if the pump is rotating backwards and switch any two 3-phase leads to the motor starter. For issues with the pump operation, refer to the pump instructions.
J
Julie SaundersAug 17, 2025
What to do if my GE Water Filtration Systems has low inlet pressure?
- A
  Alice PerezAug 17, 2025
  If your GE Water Filtration System displays a low inlet alarm due to insufficient feed water pressure, you should increase the feed pressure, open the inlet/feed valve, check for any restrictions, or consider installing a feed water boost pump. Another possible cause is a clogged pre-filter, which requires replacing the pre-filters. Also, the solenoid valve may not be opening, in which case you should clean or replace it.