m
ul
O
B
u_
_c
¢
4,
£
4,
c
!ii@i_iiii/i
iii,iiiii_i_iiiiiiii'iiii
iiiii',iiiFiiii_ii,lii
iiiiii_'_iiiii
0
¢
t
0
m
F,
m
L.
0
0..
0,,
o
E
u_
0
J
Care and cleaning of the range.
Use a sewing needle or twist-tie
to unclog the srnatl hole in the burner
head.
Burner Caps and Heads
NOTE:Before removing the burner caps
and heads, remember their size and
location. Replace them in the same
location after cleaning.
Burner caps
Lift off when cool. Wash burner caps
in hot, soapy water and rinse with clean
water.Youmay scour with a plastic scouring
pad to remove burned-on food particles.
Burner heads
Forproper ignition, make surethe small hole
in the section that fits over the electrode is
kept open.A sewing needle or wire twist-tie
works well to unclog it.
Theslits in the burner heads must be kept
cleanat a!!times for an even,unhampered
flame.
Cloggedor dirtg burner ports or electrodes
will notallow the burner to operate properly.
Ang spillon or around an electrode must
be carefullg cleaned.Takecare to not hit
an electrode with anything hard or it could
be damaged.
Youshould clean the burner caps and
burner heads routinelg, especiallgafter bad
spillovers,which could clog the openings
in the burner heads.Lift off when cool.
Toremove burned-on food, soak the burner
heads in a solution of mild liquid detergent
and hot water for 20-]0 minutes. Formore
stubborn stains, usea toothbrush.
After cleaning
Beforeputting the burner caps and heads
back, shakeout excesswater and then dry
them thoroughly by setting ina warm oven
for ]0 minutes.
NOTE:Do not use stee! woo! or scouring
powders to cleanthe burners.
Replacement
Replaceburner heads overthe electrodes
on the cooktop, in the correct locations
according to their size.
On some models:
Mediumhead small head
and Cap andcap
Frontof range
and Cap and cap
On some models:
Mediurnhead small head
and cap andcap
(
, FrontOfrange
Mediumhead Largehead
and cap and cap
Hake surethe slot in the burner head
is positioned overthe electrode.
Replacethe matching sizecaps onto
the heads.
Hake surethat the heads and caps are
replaced in the correct locations.
NOTE:Onsome models,the burnersare
a!!the same sizeand power.
28