Electrophoresis Power Supply EPS 3501 XL Operating Instructions 28-9639-69 AA 13
Introduction 1
Instrument 1.3
Output sockets
There are two sets of output sockets to allow two electrophoresis units to be connected
and run at the same time.
insert
delete
Press insert delete to insert or delete a phase in a
program. This function is activated in SET mode. Note that
a program must be completed by answering Yes (Y) to the
question “Last Phase?” in SET mode or by pressing exit
before you can use the insert delete key.
more Press more to place program in MORE mode. This gives
access to some special functions. These include:
COPY: Copying a program.
CLEAR: Clearing a program.
SETUP: Disabling the start current check.
MORE mode cannot be activated in RUN or PAUSE mode.
Leave MORE by pressing exit.
exit Press exit to stop the execution of an operation, such as
the entry of a value. Only values/units that have already
been confirmed by set enter are retained when exit is
pressed. Note that if a phase contains zeros when pressing
exit, that phase will be deleted.
Press exit to return the instrument to the mode that was
left or to the start position in SET.
Key Label Description
Inser t
delet e
mo re
exit
Output socket Label Color Voltage
Positive + Red 0 and +1750 V
Negative - Black or blue 0 and –1750 V
To Next Page
Loading...
