To Next Page

To Previous Page

31 /

9/23/2012

Error Code Mode:

Select

Cycle

Start

Press and hold 5 seconds

Door Status Check (test will last for 10 seconds)

LED’s Solid Indicates door is closed

LED’s Flashing Indicates door is open

LED

Error Type

Error Causes

Start

Communications

Failure

User Interface control is unable to communicate with

the machine control.

Heated Dry

Wash Temperature

Error

The minimum wash temperature of 120

°F was not

reached during 3 of the past 5 wash cycles.

Wash Boost

Thermistor Error

Control is detecting a short or open circuit at the

thermistor

Clean

Turbidity Sensor

Error

Control is detecting a short or open circuit at the

turbidity sensor.

Lock

Always Illuminated

Illuminates to tell user that

Diagnostic Code Display

Mode

is active.

GE GDF510PGDBB User Manual

Other manuals for GE GDF510PGDBB