GE GDP665SYNFS - User Manual

To Next Page

READ CAREFULLY

KEEP THESE INSTRUCTIONS

CHECK THE FOLLOWING

r Tub trim does not interfere with the door

r Dishwasher is square and level at both the top and bottom of the cabinet opening,

with no twisting or distortion of the tub or door

r All 4 legs of the dishwasher are firmly in contact with the floor

r Drain hose is not pinched between the dishwasher and adjacent cabinets or walls

r Tub trim is fully seated on the tub flange

WARNING

CAUTION

FOR YOUR SAFETY

Read and observe all WARNINGS and CAUTIONS

shown throughout these instructions.

IMPORTANT – Observe all governing codes and

ordinances.

• Note to Installer – Be sure to leave these instructions

for the consumer’s and local inspector’s use.

• Note to Consumer – Keep these instructions with

your Owner’s Manual for future reference.

• Skill Level – Installation of this dishwasher requires

basic mechanical, electrical and plumbing skills. Proper

installation is the responsibility of the installer.

Product failure due to improper installation is not

covered under the GE Appliances Warranty. See

Warranty information.

• Completion Time – 1 to 3 Hours. New installations

require more time than replacement installations.

IMPORTANT – The dishwasher MUST be installed to

allow for future removal from the enclosure if service is

required.

Care should be exercised when the appliance is

installed or removed, to reduce the likelihood of

damage to the power supply cord.

If you received a damaged dishwasher, you should

immediately contact your dealer or builder.

Optional Accessories – See the Owner’s Manual for

available custom panel kits.

Your dishwasher is a water heating appliance.

31-4000211 Rev 1 05-19 GEA

BEFORE YOU BEGIN

Read these instructions completely and carefully.

• To reduce the risk of electric shock, fire, or injury to

persons, the installer must ensure that the dishwasher is

completely enclosed at the time of installation.

• FOR PERSONAL SAFETY: Remove house fuse or open

circuit breaker before beginning installation. Do not use

an extension cord or adapter plug with this appliance.

• The improper connection of the equipment grounding

conductor can result in a risk of electric shock. Check

with a qualified electrician or service representative if

you are in doubt that the appliance is properly grounded.

• If house wiring is not 2-wire with ground, a ground

must be provided by the installer. When house wiring

is aluminum, be sure to use UL-Listed anti-oxidant

compound and aluminum-to-copper connectors.

• To reduce the risk of electric shock, fire, or injury to

persons, the installer should check to ensure that wires

are not pinched or damaged, the house wiring is attached

to the junction box bracket through a strain relief, and

all electrical connections made at the time of install (wire

nuts) are contained inside of the junction box cover.

Do not remove wood base until you are ready to install

the dishwasher. The dishwasher will tip over when the

door is opened if base is removed.

While performing installations described in this booklet,

gloves, safety glasses or goggles should be worn.

See your Owner’s Manual for details on how to contact us regarding installation questions

Built-In Dishwashers

Installation

Instructions

Main Page

Need help?

Do you have a question about the GE GDP665SYNFS and is the answer not in the manual?

GE GDP665SYNFS Specifications

General

Style	built in
Color	stainless steel
Load Capacity	16 place settings; up to 16 place settings
Number of Cycles	5 (heavy wash, normal wash, light wash, 1 hour wash, rinse)
Number of Options	11
Drying Type	heated & vented
Noise level	46 dba
Control Type	front controls, 8 touch pads; touchpad
Delay Start	yes
Spray Arms	3 wash levels (lower, middle, upper)
Dispenser	rinse aid dispenser with indicator and adjustment
Water Filter	yes
Leak Protection	yes
Water Softener	no
Food Disposer	yes
Sanitize Settings	yes
Half Load	yes
Wi-Fi	no
Smart Home	no
Remote Control	no
Voltage	120 volts
Current	15