EasyManua.ls Logo

GE GDT225-226 Series - User Manual

GE GDT225-226 Series
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Write the model and serial
numbers here:
Model # _________________
Serial # _________________
You can find them on a label on
the tub wall just inside the door.
GE is a trademark of the General Electric Company. Manufactured under trademark license.
OWNER’S MANUAL
DISHWASHERS
49-55124-4 06-19 GEA
ENGLISH/FRANÇAIS/
ESPAÑOL
SAFETY INFORMATION .........3
USING THE DISHWASHER
Getting Started ........................5
Dispensers ............................6
Loading ..............................8
Connecting and disconnecting
(Portable models only) ................10
CARE AND CLEANING ............ 11
TROUBLESHOOTING TIPS ......14
LIMITED WARRANTY ...........17
CONSUMER SUPPORT ..........18
PDT145 Series - Built-In
GDT225-226 Series - Built-In
GPT145 Series - Portable
GPT225 Series - Portable

Questions and Answers

  • A
    Angel ReynoldsSep 6, 2025
    How to fix black or gray marks on dishes in my GE GDT225-226 Dishwasher?
    • D
      darrendixonSep 7, 2025
      These marks usually appear because aluminum utensils have rubbed against the dishes. Remove the marks with a mild, abrasive cleaner.
  • M
    matthewsreginaNov 20, 2025
    Why are my dishes and flatware not clean in my GE GDT225-226?
    • S
      Savannah KennedyNov 20, 2025
      Several factors can cause this. The filter assembly might be clogged (see the CARE AND CLEANING section). The inlet water temperature may be too low—ensure it's correct by running the hot water faucet nearest the dishwasher until the water temperature stops rising, then start the dishwasher and turn off the faucet, and select Wash Temp - Boost (see the USING THE DISHWASHER section). Low water pressure could also be a factor; normal water pressure should be 20-120 psi. Other potential causes include a clogged air gap or disposer (for Built-In Models Only), improper rack loading (see the Loading section), or poor performing detergent. Also, if you have a Built-In Model check if high drain loop or air gap is not installed (refer to the Installation Instructions for proper drain line installat...
  • B
    Blake MooreSep 18, 2025
    What to do if rinse agent was spilled in my GE Dishwasher?
    • S
      Sara ChristianSep 18, 2025
      Always wipe up rinse agent spills immediately.
  • R
    Ryan WarrenSep 16, 2025
    Why isn't the Sanitized light illuminating at the end of the cycle on my GE Dishwasher?
    • D
      David SilvaSep 17, 2025
      The door may have been opened, interrupting the cycle during the final rinse. Avoid opening the door during the wash cycle. Also, the incoming water temperature may have been too low; raise the water heater temperature to between 120°F and 150°F.
  • S
    smithbrianSep 15, 2025
    What does it mean if my GE GDT225-226 BEEPS once every minute?
    • K
      Kristin RhodesSep 15, 2025
      This is a reminder that your dishwasher door has been left open during operation. Press Start and close the door.
  • B
    Brandon YoungSep 13, 2025
    What does it mean if the start status indicator light is flashing on my GE Dishwasher?
    • J
      John DanielSep 13, 2025
      The flashing light indicates that the door was opened or the cycle was interrupted. Press the Start pad once and close the door within 4 seconds to start the dishwasher. Press the Start pad a second time when the dishwasher is running only if you wish to cancel the cycle.
  • L
    llangSep 12, 2025
    Why does my GE GDT225-226 have a stained tub interior?
    • C
      Cindy WalkerSep 12, 2025
      An overall yellow or brown film can be caused by iron deposits in water. A special filter in the water supply line is the only way to correct this problem. Contact a water softener company. White film on the inside surface is usually hard water minerals. We recommend Finish® Jet-Dry® Rinse Aid to help prevent hard water mineral deposits from forming. You can also run the dishwasher with citric acid to remove mineral deposits. Citric acid (Part number: WD35X151) can be ordered through GE Appliances Parts. Alternatively, purchase Finish® Dishwasher Cleaner and follow the directions on the label.
  • S
    Stacey JohnsonSep 10, 2025
    Why is detergent left in the dispenser cups of my GE GDT225-226?
    • M
      Mark RamirezSep 10, 2025
      This is usually because dishes or utensils are blocking the detergent cup. Reposition the dishes so the water from the lower spray arm can flush the detergent cup (see the Loading section). Also, reposition tall utensils or heavy silverware that may be keeping the dispenser cup door from opening.
  • P
    paulhudsonSep 8, 2025
    Why is my GE GDT225-226 making noise?
    • P
      Patricia BassSep 8, 2025
      Normal operating sounds include beeping at the end of the cycle, the detergent cup opening, water entering the dishwasher, the motor stopping and starting, the spray arms starting and stopping, and drain pump sounds. These are all normal. If dishes are rattling, make sure they are properly loaded. If silverware is rattling against the door, tall utensils may be placed in the upper rack.
  • R
    Ruben ReevesAug 23, 2025
    What to do if my GE GDT225-226 won’t run?
    • E
      elizabeth10Aug 23, 2025
      First, check if a fuse is blown or a circuit breaker is tripped; replace the fuse or reset the breaker, and remove other appliances from the circuit. Ensure the power is turned on, especially if it's controlled by a wall switch. The control panel might be locked; unlock it (see the Getting started section). As a last resort, try rebooting your control by turning off power to the dishwasher (at the circuit breaker or wall switch) for 30 seconds, then turning it back on.

GE GDT225-226 Series Specifications

General IconGeneral
TypeBuilt-In
Drying SystemHeated Dry
Control TypeElectronic
Number of Options4
Water Filtration SystemYes
Racks2
Silverware BasketYes
Interior LightingNo
Leveling LegsYes
Energy Star CertifiedYes
Delay StartYes
Third RackNo
Water HeaterYes
Dry OptionHeated Dry
Lower Rack FeaturesAdjustable
Dimensions (W x H x D)24 in x 34 in x 24 in

Related product manuals