Sound Barrier
Bottom Front View
Tape
:LWKGLVKZDVKHURQWKH
wood base, check the
door balance by opening
and closing the door.
'RRULVSURSHUO\EDODQFHG
if, when opened, it self
closes within 20° from
vertical, stays in position
from 20° to 70° and falls
fully open beyond 70°.
Dishwasher Installation
Figure G
6FUHZOHYHOLQJOHJVEDFNLQWRWKHGLVKZDVKHUIUDPH
approximately 1/2" from frame as shown.
Approx.
1/2"
STEP 3: REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT – 'RQRWNLFNRȺZRRGEDVH
Damage will occur.
0RYHWKHGLVKZDVKHUFORVHWRWKHLQVWDOODWLRQORFDWLRQDQGOD\
it on its back.
5HPRYHWKHOHYHOLQJOHJVRQWKHXQGHUVLGHRIWKHZRRGEDVH
with a 15/16" socket wrench.
'LVFDUGEDVH
STEP 1: PREPARATION
Locate the items in the installation package:
6FUHZV
-XQFWLRQER[FRYHU
'UDLQKRVHDQGFODPS
0RXQWLQJEUDFNHWV
7ULPSLHFHVRQVRPHPRGHOV
'UDLQKRVHKDQJHU
2ZQHUV0DQXDO
3URGXFWVDPSOHVDQGRUFRXSRQV
Figure H
Toekick
Remove 2
Toekick Screws
STEP 4: REMOVE TOEKICK
5HPRYHWKHWRHNLFNVFUHZVDQGWRHNLFN6HWDVLGHIRUXVHLQ
Step 22.
Figure I
6
Tip: Make sure door opens and closes smoothly.
Check door opening and closing. If door does not open easily or
falls too quickly, check spring cable routing. The cable is held in
place by “shoulders” on the pulley. Check to be sure cable has
not slipped over the pulley shoulders and is routed as shown.
6LGH9LHZ
Make sure
pulley cable
is within
pulley
shoulders
)URQW9LHZ
,IQHFHVVDU\LQFUHDVHRUGHFUHDVHWHQVLRQDVVKRZQ/DWFK
door and adjust both springs to the same tension setting to
correct balance.
STEP 2: CHECK DOOR BALANCE
Door
closes
within
20°
Door stays in
position from
20° to 70°
Door falls fully
open beyond 70°
6LGH9LHZ
STEP 5: POSITION SOUND BARRIER
(on some models)
Skip this step if the sound
barrier is not assembled
to the dishwasher.
Lift the sound barrier and
tape to the door front with
masking tape. This will
hold the sound barrier up
and out of the way during
installation.