The SYSTEMS MONITOR
(continued)
DISPLAY
LOW
WATER
TEMP
TEMP
SENSOR
WHAT IT MEANS
The water temperature in the
dishwasher did not reach the
proper wash temperature. This
is usually caused by lack of hot
water coming from the household
water heater.
The temperature sensor in the
dishwasher is not functioning
properly. Dishwasher may
continue to be used, but it will
not heat water automatically.
Before you call for service
.
Try the cycle again to see if the
Code reappears. The dishwasher
may correct itself.
. Electronic controls can be
affected by outside interference.
● Sometimes shutting off the power
to the dishwasher (at the fuse or
circuit breaker) will correct the
problem.
. Restore power after about five
seconds and try the cycle again.
● Check the guide for things you
can do to correct the problem.
WHAT TO DO
Avoid showers or laundry just prior to running the
dishwasher. (Use the “DELAY START” feature to start
dishwasher when the water heater is up to normal
temperature. ) Adjust household water heater thermostat to
120°F.
minimum
If LOW WATER TEMP appears nearly every cycle and you
know the water from the household water heater is hot
(120°F. or more), call for service.
The temperature sensor needs to be replaced.
Call
for
service.
NOTE:
You may continue to use your dishwasher. For best results
adjust your household water heater thermostat to
140”F.
10
To Next Page
Loading...
