DOOR LATCH “OFF” POSITION
/
STEP 6
tions
Soil Options Heating Options
f
CHINA RINSE HEAVY NORMAL LIGHT
CRYSTAL & HOLO
HEATEO
SOIL
SOIL SOIL RINSE
It
8s8
t
‘E:;’
m
00000 0,0
@m
7
/
,
STEP4
Select a Soil Option
If you wish to make program
changes, start with the soil level.
Y
OU should select a change within
30 seconds, otherwise all panel
lights will go out. To relight, touch
any pad or open and
re-close
door.
● HEAVY SOIL should be
selected when dishes are extra
soiled or extra greasy. This gives
dishes an extra rinse in every cycle
except RINSE & HOLD. This
lengthens
cycle.
● NORMAL SOIL is automatically
programmed when a cycle is
selected. You may want to change
the selection depending on the soil
on your dishes.
. LIGHT SOIL
will
save time and
money if you pre-rinse your
dishes. This shortens
all
cycles
except RINSE & HOLD.
STEP 5
Select a drying option
● HEATED DRY on—Provides
faster drying. Can be changed
while cycle is running.
● HEATED DRY off (Energy
Saver)—Shuts
off
heating unit.
Dishes air-dry naturally. It takes
longer, but saves energy. You can
prop door open about 3 inches
after motor stops to speed drying.
Excellent for overnight drying.
Energy Saver helps reduce
electrical energy used by this
model approximately
6~o.
● HEATED RINSE—Select with
either POTSCRUBBER or
NORMAL WASH. Heats water in
final rinse to
140°F.–1450F.
Touch
pad once for on, once more for off.
This option may be changed at any
time before or after start of cycle.
When selected, the cycle may
extend up to 20 minutes while the
machine heats the water. During
the heating extension the minutes
countdown is on hold.
Start the dishwasher
● When you’re ready to wash
dishes, touch the START pad.
There is a time delay between
start-up and water fill so you
will not hear any wash action
right away. Dishwasher
will
proceed through your entire
program and turn off automatically.
To delay the start, touch DELAY
START pad. The SYSTEMS
MONITOR will read “1
hrs
delay.”
Touch pad once again for each
hour desired up to 9 hours. The
machine will count down and start
automatically at the correct time.
Note: Don’t forget to put detergent
in cup and close cup. Do not use
DELAY START with the RINSE &
HOLD cycle.
To change a cycle after washing
starts, touch the CLEAR RESET
pad to cancel cycle. After water
is pumped out and motor stops,
you can reprogram and restart
the dishwasher.
5
-—
—
..—
.—
To Next Page
Loading...
Need help?
General
