GE GSD970 P - How to Operate the Dishwasher; Wash Heat Boost Option; For Potscrubber, Normal Wash and Light Wash Cycles; For Rins & Hold Cycle

Howtooperateyour dishwasher
POT. MOWN UOHT RIME
W$S;o~T tlEATEO 5NENIW
SCSUBBER WASH WASI 8 HOW
\
OIIY SAVER
,.w,6Qm
F====i
@
,T@F
~)
Potscrubber
~,1,,
STEP 1. Load your dishwasher
with dishes, silverware, pots,
pans, bowls, etc., according to
instructionson pages 8-10.
STEP2. Add detergent to the
detergent dispenser.Make sure the
Cycle Indicator Dial is at OFF
position before adding detergent.
(See pages 6 and 7.)
Use rinse aid agent to help prevent
spotting. Occasionally check to
insure that rinse agent container is
at least half full..(See page 6.)
STEP3. Select drying option.
HEATED DRY.Turns the drying
heater on for fast drying.
ENERGY SAVER(no-heatboost).
Turns thedrying heater off to save
energy.Dishes will dry naturally
over a longerperiod suchas
overnight.
If you need your dishes sooner,
open the dishwasher door after the
cycle is complete to reduce the
natural drying time.
P&k: The ENERGY SAVER
option will also cancel the WASH
HEAT BOOST. To obtain WASH
HEAT BOOST without HEATED
DRY, select only the WASH HEAT
BOOST option. (See Energy-
Saving Tips on page 2.)
STEP 4. WASH
HEATBOOST
Option.
kwRpH;AT
❑
When selected, the cycle will be
extended for 21 minutes while the
dishwasher heats the water for
good washing and drying. The
entering water must be at least
120°F.
When this option is not selected,
the entering water must be at least
140”E To test water temperature,
see page 6.
STEP 5. Select the wash cycle and
start the dishwasher.
If your dishwasher drains into a
food waste disposer, operate the
disposer until it is empty before
starting the dishwasher. (See Cycle
Selection Hints on next page.)
0I?or
PoTsaWBBER9
NORMAL WASHand LIGHT
WASHCycks:
PoT-
NORMAL LIWT
SCRUBBERWASHWASH
a. Push selected cycle button.
b. Latch the door.
c. Slowly turn Cycle Indicator
❑
✎
✎
✎
✎
❑
Dial to ON position to start the
cycle. Youwill hear the motor
start. There is a time delay
between start-up and water fill
so you will not hear any wash
action right away.
To obtain the benefits of a
complete cycle, be careful that
you do not
turnthedialany
h.mtherthannecessary
to start
the dishwasher.
~ForRINSE& HOLDcycle:
o
RINSE
&HUD
c1
a. Push RINSE & HOLD button.
b. Select ENERGY SAVER
drying option.
c. Latch the door.
d. Slowly turn Cycle Indicator Dial
to ON position to start the cycle.
4