EasyManua.ls Logo

GE GUD27GSSMWW - Page 70

GE GUD27GSSMWW
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 70 –
Fault
Code
Fault Name Description Repair Action
12 Redundant Flood
Condition
Backup processor received an
extended period of pressure readings
WKDWLVQHDULQJRYHUÀRZOHYHOV&RXOG
mean water did get that high due to
EULHÀ\VWXFNZDWHUYDOYH9ROWDJH
output of sensor too high for actual
water level because of sensor or water
in pressure tube increasing pressure.
 Check pressure tube for
trapped water.
 Check each valves operation.
(Replace water valve and send
back to GE Appliances.)
 Check the output voltage from
the pressure sensor to ensure
it matches the water level in
the basket according to the
pressure sensor chart.
 Check pressure tube for
pinches where it goes through
top cover grommet
 Ensure pressure chamber port
is free from obstruction using
drill bit size 1/16" by hand so
as not to drill through the inner
wall.
13 Redundant Lid
Unlocked
In spin mode, the lid switch feedback
has voltage (lid closed), for more than 5
seconds the motor speed feedback
assumes the basket is spinning > 65
RPM when the lid lock feedback has no
voltage (Lid Unlocked).
Lid Switch Feedback has no Voltage
when the BRPM is > 65 RPM.
 Check lid switch continuity at
J513 on the control.
 Check continuity of lid lock
position. Opened or Closed.
 Check for proper operation
of lid lock. 120 VAC while
activating
 Check lid lock wiring
harness from the control to
lock assembly.
15 Water Temp
Sensor Invalid
1. Thermistor disconnected/not present.
2. Failed thermistor.
 Check thermistor resistance
from connector J701 on the
control board. Validate the
resistance matches the table
in mini-manual.
 Check wiring harness and
connections.
 Replace thermistor.
17 Dry Load Sense
Timeout
Dry load sense times out and moves to
the next part of the cycle selected. This
occurs when washer is not reaching
WDUJHWVSHHGZLWKLQDGH¿QHGWLPHOLPLW
for load type selected.
1. Check for water in the
bottom of the tub. If so,
drain and try cycle again.
2. Check the basket for
excessive friction. Basket
should spin freely. If not,
¿QGVRXUFHRIIULFWLRQDQG
remove it.

Table of Contents

Other manuals for GE GUD27GSSMWW

Related product manuals