4-32 12" QuickPanel* View Intermediate, Color and Monochrome – December 2010 GFK-2306E
Note: Do not adjust switches other than switch 2. They are reserved for
factory functions. Also note that the “Off” position of the switches is
toward the DIMM connector, “On” toward the COM1 connector.
To configure startup behavior
Caution
Disconnect power from your DC power supply before opening
the QuickPanel View. Working on a “live” unit may result in
damage to equipment and injury to personnel. Always use
anti-static precautions (i.e. grounded wrist strap) when
accessing the interior of the unit.
Caution
Do not allow conductive material, either liquid or solid, to
contact the electronics of the QuickPanel.
1. Open the back cover of the QuickPanel View.
2. Locate the DIP switches and set DIP switch 2 to “ON”. The startup
applications are now forced.
Note: Do not adjust the other switches. They are reserved for factory
functions.
To Next Page
