10 49-60698-4
Installation Instructions
2
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF/HDYH
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
3
INSTALL THE MOUNTING
SCREWS
Ɣ Skip to Step 4 if screws are already in place in
the freezer side wall.
Ɣ ,QVWDOOWZRVHOIWDSSLQJ
Phillips head screws
from the kit in the holes in
the side wall. The screw
heads should extend about
PPIURPWKHVLGH
wall.
4
INSTALL THE ICEMAKER
FILL CUP
,QVWDOOWKHLFHPDNHUILOOFXSHQGPRXQWHG
that came with your unit into the icemaker as
VKRZQ,IWKHILOOFXSKDVEHHQPLVSODFHGFDOO
DQGRUGHUSDUW:5;
ICEMAKER INSTALLATION INSTRUCTIONS
T
- IM4D ONLY
1
PREPARE FOR INSTALLATION
Ɣ 5HPRYHWKHVWRUDJH
EDVNHWRQVRPHPRGHOV
by pulling it out to the
stop position and lifting it
up and out.
NOTE: After removing
the basket, push the
extension arms back into
the freezer compartment.
Ɣ5HPRYHWKHFKLOOHUVKHOI
RQVRPHPRGHOVE\
pulling it straight out.
Ɣ5HPRYHWKHFHQWHU
YHUWLFDOVKHOIVXSSRUWRQ
some models) by lifting it
and rotating its bottom to
the right.
Ɣ,QVLGHWKHIUHH]HU
remove the two small
white plug buttons
RQVRPHPRGHOV
IURPWKHVLGHZDOO,I
screws are present
instead of plugs,
leave them in place.)
Ɣ5HPRYHDQGGLVFDUG
the large white plug
from the rear freezer
wall.
Ɣ5HPRYHWKHRXWOHWFRYHUZLWKDIODWEODGH
screwdriver.
Flat blade and Phillips
screwdrivers
Pliers
Sharp knife
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow
these instructions can result in electrical
shock.
TOOLS YOU WILL NEED
Outlet
cover
5HPRYHVLGHZDOOSOXJEXWWRQV
or leave screws in place
5HDUZDOO
plug button
Power
Switch
$SSHDUDQFHPD\YDU\
INSTALLATION INSTRUCTIONS
To Next Page
Loading...
Need help?
General
