EasyManuals Logo

GE JKP90 Installation Instructions

GE JKP90
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Installation Instructions
Cutout for Built-In Oven with
Microwave models only
a Warming Drawer
For JKP90, JTP90, PT970 models only.
27" (68.6 cm) Oven with
Microwave Oven (Model
JKP90) Over a Warming
Drawer
- Over
30" (76.2 cm) Oven with
Microwave Oven (Models
JTP90 and PT970) Over a
Warming Drawer
Anti-Tip Block
Against Rear
Wall Per
Warming Drawer
Requirement
2" (5,1 cm)
Min.
Anti-Tip Block
Against Rear
Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
Per Warming
Drawer
Requirement
1" (2.5 cm) Min. Above Toekick
Per Warming
Drawer
Requirement
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth and
height,
1" (2.5 cm) Min. Above Toekick
When installing a Warming Drawer below
a single or double oven, a separate 120V,
60 Hz, properly grounded receptacle must
be installed. Refer to installation instructions
packed with the Warming Drawer for
specific installation requirements.
6

Other manuals for GE JKP90

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE JKP90 and is the answer not in the manual?

GE JKP90 Specifications

General IconGeneral
BrandGE
ModelJKP90
CategoryOven
LanguageEnglish

Related product manuals