1
27” Built-In Wall Oven
Installation
Instructions
JKP20, JKP25, JKP28, JKP48, JKP50, JK915,
JK955, JKS06, ZEK938, ZEK958
If you have questions, call 1.800.GE.CARES or visit our website at:
www.GEAppliances.com
Before You Begin
Read these instructions carefully and completely.
• IMPORTANT—Save these
instructions for local inspector’s use.
• IMPORTANT—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
• ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Tools Needed
1/8” Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Materials Needed
Strain Relief Clamp
for 1/2” conduit
Junction
Box
Wire Nuts
36” of String
229C4053P504-4
31-10523-4 06-04 JR
Parts Included
Screws for
Installation
Optional
Metal Bottom
Trim Assembly
(on some models)
Plastic
Bottom Trim
Optional
Metal Bottom Trim
Metal
Bottom Trim
To Next Page
Need help?
General
