Cleaning the glass cooktop. , .GEApp,o,cos.co=
Control Lock Pad
Begin by locking the cooktop; see
the Locking the Cooktop section. Use
the same cleaning methods as those
described for the glass ceramic top.
Clean your cooktop after
each spill
Normal Daffy Use Cleaning
ONLY use file recommended cleaning
cream, Cerama Btyte ®,on the glass
cooktop. Other creams may not be __s
effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
[] Befitre using the cooktop for the
first time, clean it with the cooktop
deaning cream. This helps protect
file top and makes clean-up easier.
[] Daily use of the cooktop cleaning
cream will help keep the cooktop
looking new.
[] Shake the cleaning cream well.
Apply a few drops of the cream
directly to the cooktop+
[] Use a paper towel or sponge m clean
the entire cooktop surface.
NOTE:It is vary important that youDONOT
heat the cooktopuntil it has beencleaned
thoroughly
Scotch-Brite_ MuRi-Purpose
NoScratch scrub sponge
Burned-On Residue
WARNING: DAMAGEto yourglass surface
may occurif youusescrub pads other than
BLUEScotch-Brite_ Multi-Purpose No Scratch
scrub spongesby 3M.
[] Allow the cooktop tit cool.
[] Spread afewdrops of Cerama
Bryte ®to the entire burned residue
area+
[] Using the scrub sponge, rub the
residue area, applying pressure as
needed.
[] If any residue remains, repeat the
steps listed above as needed.
[] For additional protection, after
all residue has been removed,
polish the entire surface with
Cer0xna Bryte ®and a paper tt)wel.
+++++++++++++++++++++++;+:+++Heavy, Burned-On Residue
[] All+theo++kt+t,, []
p2t?°t,,the+,,tirebu,,,edresidue []
] Iqold the razm- scraper at
NOTE:Razorbladeis packed
invertedforsafety reasons. Priorto
use,theblademustberotatedand
reinsertedintoslot,Donotusea
dullornickedblade.
The RAZOR SCRAPER is available
through our Parts Cente_ See
instructions under "To Order Parts"
section on next page.
apprctximately a 45 ° angle against
the glass surface and scrape the
soil. It will be necessary tit apply
pressure to the razor scraper in
order to remove the residue.
Keep a small amount of cream oi1
the residue as you scrape.
After scraping with the razor
scraper, use the scrub sp<mge to
remove any remaining residue.
For additional protection, after
all residue has been removed,
polish the entire surface with
Cerama BzTte ®and a paper towel.
13
To Next Page
Loading...
