OPEWTING THE SELF-CLEANING OVEN
(continued)
How to Set Oven for Cleaning
r
Quick Reminder:
1.
Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
If the oven is too hot and you start to set a clean
cycle, the word “OFF” will appear in the display.
Allow additional time for cooling before you try to
set the cycle.
1.
Follow the directions in the Before a Clean
Cycle section.
r
~
2. After
closing
the door, press the AUTO
‘ AUTO SELF
CLEAN
SELF CLE~N pad. “
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the
time
for the clean
cycle is set. The words “ON” and “LOCK” will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
4. When the LOCK light is off, open the door.
NOTE:
n
● You can find out when the clean cycle
y~:[
will be finished by pressing the STOP
A
TIME pad.
● The word “door” will be displayed, the word
“LOCK” will
flash
and oven control will signal if you
set the clean cycle and forget to close the oven door.
A
3. Press the INCREASE or DECREASE
● A fan may automatically turn on and
off
to
cool
Q
pad until the desired Clean Time is
internal parts. This is normal, and the fan may
displayed.
continue to run after the oven is turned off.
v
Clean Time is normally 3 hours. You can
@
change the Clean
TimetO
anytime between
2 and 4 hours, depending on the amount of
soil in your oven.
—
—
To Stop a Clean Cycle
o
1.
Press the CLEAWOFF pad.
2. When the LOCK light goes off and the oven has
CLEAR
cooled below the locking temperature, open the door.
OFF
—
30
To Next Page
Loading...
