.*fter
Self-Cleaning
You
may
notice some white ash in the oven. Just wipe
If the oven is not
clean after one clean cycle,
it up with
a
damp cloth after the oven cools.
repeat the cycle.
If white spots remain, remove them with a soap-filled
If the shelves become hard to slide, wipe the shelf
~teel
wool
pad
Be sure to rinse
thoroughly
with
supports with cooking oil.
a vinegar and water mixture.
These deposits are
NOTE: No functions can be programmed before the
usually a salt residue that cannot be removed by the
door automatically unlocks.
clean cycle.
How to Set Delay Start of Cleaning
Quick Reminder:
1.
Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
Delay Start is setting the oven timer to start the clean
cycle automatically at a
later
time than the present
‘me
of day.
.
~OTE:
Before beginning, make
sure the oven clock
shows the correct time of day.
1.
Follow the directions in the Before a Clean
Cycle section.
n
2. After closing the door, press the AUTO
AUTO SELF
CLEAN
SELF CLEAN pad.
3. Press the INCREASE or DECREASE
@
pad to enter Clean Time.
5. Press the INCREASE pad to change the Stop Time
to a later time of day
if
desired.
For example: If
you set Stop Time at 11:00, oven will start clean
cycle at
8:00
and end at 11
:00.
The door latches
automatically.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for clean cycle
is set. The words “ON” and “LOCK” will appear in
the display when the door automatically locks.
It will not be possible to open the oven door until
the temperature drops below the lock temperature
and the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
n
●
During a delayed self-clean operation you
AUTO SELF
CLEAN
can find out when the oven is set to turn
A
on by pressing and holding the
AU-TO
SELF CLEAN pad for
3
seconds.
● A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
(c’o17ti?l14e[/
tle.rr
II<lge)
❑
4. Press
the
STOP TIME pad. “STOP
y~:[
T]
ME”
and
the earliest Stop Time
yOLI
L
can set will appear in the display.
The earliest Stop Time will be the Clean Time
selected plus the time of day.
For example:
If
the
Clean Time is three
hours
and
the time of day is
6:00,
the Stop Time that appears in the display will be
9:00.
31
To Next Page
Loading...
