QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
“F-- AND A NUMBER”
FLASH IN THE DISPLAY
OVEN WILL NOT WORK
OVEN LIGHT
DOES NOT WORK
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT ROAST
OR BAKE PROPERLY
CLOCK AND
MINUTE/SECOND
TIMER DO NOT WORK
OVEN WILL NOT
SELF-CLEAN
DOOR WILL NOT OPEN
A~ER
SELF-CLEAN CYCLE
CONTROL SIGNALS AFTER
ENTERING OVEN TIME
OR STOP TIME
OVEN TEMPERATURE TOO
HOT OR TOO COLD
“BURNING” OR “OILY”
ODOR EMITTING FROM
OVEN WHEN TURNED ON
STRONG ODOR
OVEN NOT CLEAN AFTER
SELF-CLEAN CYCLE
“door” APPEARS
IN THE DISPLAY
POSSIBLE CAUSE
●
This is function error code. Press the
CLEAWOFF
pad. Allow the oven to cool
one hour. Place the oven back into operation. If function error occurs again,
disconnect
Dower
to the oven and call for service.
●
The circuit breaker in your house has been tripped, or a fuse has been blown.
● The oven controls are not properly set.
●
The light
bulb
is loose or defective. Tighten or replace.
●
The switch operating the oven light is broken. Call for service.
●
Oven controls not set properly. See the Broiling section.
* Door not left open to the broil stop position as recommended.
●
Improper shelf position being used. See the Broiling Guide.
●
Food is being cooked on a hot pan.
●
Cookware is not suited for broiling.
●
Low voltage. See the Broiling section.
●
Aluminum foil used on the broiler pan and rack has not been fitted properly
and slit as recommended.
●
Oven controls not set properly. See the Baking or Roasting section.
●
Shelf position is incorrect. See the Roasting or Baking section.
Q
Incorrect cookware or cookware of improper size is being used.
● Oven thermostat needs
ad.lustment.
See the
Ad.iust
the Oven
Thermostat—
Do It Yoursevsection.
-
● Check for a power outage.
●
See
the Oven Control, Clock and Timer section.
●
Oven temperature is too high to set self-clean operation.
Allow the oven to cool to room temperature and reset the controls.
. When the temperature has fallen below the locking temperature,
the door can be opened.
●
This is reminding you to enter a bake temperature.
Q
Oven thermostat needs adjustment. See the Adjust the Oven Thermostat—
Do
Zt
Yourself
section.
●
This is normal in a new oven and will disappear in time. To speed the process,
set a self-clean cycle for a minimum of 3 hours. See the Operating the Self-
Cleaning Oven
s~ction.
●
An odor from
the
insulation around the inside of the oven is normal for the
first few times the oven is used. This is temporary.
●
Oven controls not set properly. See the Operating the Self-Cleaning Oven section.
●
Heavily
soiled
ovens require 3 ‘/z- to 4-hour Clean Time.
●
Heavy
spillovers
should be cleaned up before starting the self-cleaning cycle.
●
Oven door not closed after self-clean cycle is selected.
●
Door is still locked and you are trying to enter an oven cooking operation.
If you need more help.. call, toll free:
GE Answer
Center@
800.626.2000 consumer information service
26
To Next Page
Loading...
