Installation Instructions
ADAPTING BLOWER
FOR RECIRCULATION
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want to
save them for possible flmne use.
_!_ Remove and that hold blower andplate
save screws
blower unit to the oven.
Blower PlateScrews
BlowerPlate
' ' Backof Oven
_e--- Blower MotorScrew
[]Slide the blower plate flom under its retaining
flange and lift it off\
Retaining
Blower Plate
Carefull), pull out the blower unit The wires
[] . " ...... .
wdl extend far enough to allow you to adjust the
blower unit.
[]Roll the blower unit 90 ° so that fan blade openings
are facing toward the flont of the oven.
R011
20
To Next Page
Loading...
