How to fix 'Cannot read Tape ID' on GE Logiq 500 Medical Equipment?
If the GE Medical Equipment displays the message 'Cannot read Tape ID. Register the new tape? (y/n)', it could be due to inserting an unregistered new tape or the system's inability to read the tape ID. To resolve this, you can type 'y' to register the new tape, or type 'n' to re-attempt reading the tape drive.
What to do if GE Logiq 500 says 'Requested information doesn’t exist on the tape'?
If the GE Medical Equipment displays 'Requested information doesn’t exist on the tape', it means the patient image is not on the tape. To solve this, first verify the search conditions and try again. If that doesn't work, cancel the image search and press Ctrl and T to start a tape search to locate the tape with the relevant patient data. Then, insert that tape into the VCR and attempt the image search again.
What to do if GE Logiq 500 Medical Equipment says 'Requested information doesn’t exist in System'?
If the GE Medical Equipment displays 'Requested information doesn’t exist in System', it means the patient information is not on the hard drive. To solve this, first verify the search conditions and try again. If that doesn't work, cancel the tape search and re-attempt the search on the correct system.
How to troubleshoot 'Check VCR' error on GE Medical Equipment?
If the GE Medical Equipment displays 'Check VCR' and there is no signal input or response from the VCR, you should: 1) Check the VCR power cord and all cable connections. 2) Check the settings of the LOGIQ? 500 System Parameters menu page 5. 3) Check the VCR switch settings.
Why does my GE Logiq 500 say 'Recording is not available'?
If the GE Medical Equipment displays 'Recording is not available', it means the tape is not registered to the system and all attempts to check have been completed. Use a new tape or find the proper system tape to resolve this issue.
How to fix 'Protected. Check Tape' error on GE Logiq 500 Medical Equipment?
If the GE Medical Equipment displays 'Protected. Check Tape', it indicates that the tape is write-protected. To resolve this, use an unprotected tape.
What to do if GE Logiq 500 Medical Equipment says 'Check VCR. No Cassette'?
If the GE Medical Equipment displays 'Check VCR. No Cassette', it means the VCR has no tape. To resolve this, insert a tape into the VCR.
What does 'ID collation is complete, but Ext Video doesn’t light up' mean on GE Logiq 500 Medical Equipment?
If the GE Medical Equipment displays 'ID collation is complete, but Ext Video doesn’t light up', it means a VCR-related key was pressed during ID collation. To resolve this, eject the tape from the VCR, turn the system power off, and restart the system.
Why can't I insert a tape into the VCR on my GE Logiq 500 Medical Equipment?
If the GE Medical Equipment displays 'Tape cannot be inserted into the VCR', it could be due to two reasons: * The VCR already has a tape inside. * Condensation has occurred in the VCR. If the VCR indicator AUTO OFF is lit, wait for the AUTO OFF LED to go off.
What to do if GE Logiq 500 Medical Equipment says 'Please play VCR image and freeze at the other frame'?
If the GE Medical Equipment displays 'Please play VCR image and freeze at the other frame', it means the image information on a tape cannot be read. To resolve this, advance the tape a few frames, then freeze the image.
General| Brand | GE |
|---|---|
| Model | Logiq 500 |
| Category | Medical Equipment |
| Language | English |
To Next Page
