GE MDS TransNEXT NET9L - Page 33

MDS 05-7280A01, Rev. A MDS TransNEXT Technical Manual 33
},
eth: {
ipaddr: 192.168.1.1
netmask: 255.255.255.0
gateway: 192.168.0.0
},
com1: {
baud: 115200,
databits: 8,
parity: "N",
stopbits: 1,
rxd: 0,
cts: 0,
ctshold: 0,
device: "dce",
port: "rs232",
rtu: "off",
rtuid: 0
},
radio: {
power: 20,
addr: 7552,
xaddr: 0,
hoptime: 7,
fec: "on",
retry: 0,
repeat: 3,
saf: "off",
xpri: 255,
xmap: 0x00000000,
skip: [8,1,0,0,0,0,0,0],
unit_addr: 4567,
mode: "R"
},
ippl: {
enabled: "off",
mode: "udp",
talk_on_vrc: 1,
listen_to_vrc: 1,
local_ip_port: 30011,
ip_peer_addr: 192.168.1.1
ip_peer_port: 30011,
connection_timeout: 0,
keepAlive: "off"
},
dlink: {
enabled: "on",
type: "node",
tcp_access: "off",
connection_timeout: 0,
tcp_port: 30020,
trend_resp_win: 120
},
password: {
min_chars: 1,
max_chars: 64,
min_lower_case: 1,
min_capital_letters: 0,
min_numbers: 0,
min_non_alpha_numeric: 0,
permit_username: "on"
}
}
To display configuration settings for a single Attribute Group, enter a command like the following:
>cfg get owner
{
message: "TransNEXT",
name: ""
}