EasyManua.ls Logo

GE Monogram ZIPP360NHSS - Icemaker Control Logic; Water Fill Control and Timing

GE Monogram ZIPP360NHSS
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 28 –
Icemaker Removal
Remove both freezer baskets and the drawer front to access the icemaker. The icemaker is removed by
loosening the two Phillips screws just above the mold. Disconnect the 6 pin electrical connector then lift up
and out on the assembly. See the Icemaker section in this service guide for more details.
The LFHPDNHUVZDWHU¿OOLVFRQWUROOHGE\WKHmain board K3 relay by supplying 120 VAC to the isolation and
water valves from connector J7 pin 3.
If the defrost heater is on, the Fill Tube Heater relay will be on.
After the Fill Tube Heater is on during defrost, the water valve relay will not be energized. The water valve will
require input from the icemaker to energize the K3 relay.
7KHLFHPDNHUUHOD\ZLOOWXUQRQ,02ȺWLPHDIWHUWU\LQJWR¿OOWRPLQXWHVDIWHUWKHmain board receives
input from the icemaker.
Upon the completion of 20 seconds of continuous input from the icemaker to the K3 relay, the K3 relay will
WXUQRȺ
After receiving input from the icemaker, the PDLQERDUGZLOOWXUQWKH¿OOWXEHKHDWHUUHOD\RQGXULQJWKH,02Ⱥ
WLPHDIWHUWU\LQJWR¿OOWRVHFRQGV)DOOEDFNWLPHLVVHFRQGV
:KHQWKH¿OOWXEHKHDWLQJF\FOHFRPSOHWHVWKHLFHPDNHUZDWHUYDOYHZLOOWXUQRQIRUVHFRQGVWR¿OOWKH
icemaker with water.
The ZDWHUYDOYHFDQRQO\FRPHRQDIWHUWKHLQSXWIURPWKHLFHPDNHUDQGWKH¿OOWXEHKHDWHU2QWLPHKDV
expired.

Related product manuals