CHAPTER 1: INTRODUCTION INTRODUCTION
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 1–13
Z Once the login prompt appears, login as manager using default
password (manager).
Z Configure the IP address, network mask and default gateway as
per the IP addressing scheme for your network.
Z Set the manager password (this step is recommended; refer to the
following section).
Z Save the settings (without saving, the changes made will be lost).
Z Power off the switch (or a firmware reboot as discussed below).
Z Power on the switch - login with the new login name and password.
Z From the PC (or from the switch) ping the IP address specified for
the switch to ensure connectivity.
Z From the switch ping the default gateway specified (ensure you are
connected to the network to check for connectivity) to ensure
network connectivity.
Syntax:
ipconfig [ip=<ip-address>] [mask=<subnet-mask>] [dgw=<gateway>]
An example is shown below.
ML2400# ipconfig ip=3.94.247.41 mask=255.255.252.0
dgw=3.94.247.41
ML2400# save
Note
This manual assumes the reader is familiar with IP addressing schemes as well as how net
mask is used and how default gateways and routers are used in a network.
Reboot gives an opportunity to save the configuration prior to shutdown. For a reboot,
simply type in the command
reboot. Note that even though the passwords are not
changed, they can be changed later.
ML2400# reboot
Proceed on rebooting the switch? ['Y' or 'N'] Y
Do you wish to save current configuration? ['Y' or 'N'] Y
ML2400#
The ML2400 forces an answer by prompting with a “Y” or a “N” to prevent accidental
keystroke errors and loss of work.
The parameters can be viewed at any time by using the
show command. The show
command will be covered in more detail later in various sections throughout the
document.
The example below illustrates the basic setup parameters. You can use
show setup or
show sysconfig commands to view setup parameters.
ML2400# show setup
Version: ML2400 build 1.6.1 Apr 29 2005 11:10:13
MAC Address: 00:20:06:27:0a:e0
IP Address: 3.94.247.41
Subnet Mask: 255.255.252.0
Gateway Address: 3.94.244.1
CLI Mode: Manager
System Name: ML2400
To Next Page
Loading...
Need help?
General
