GE MultiLink ML1600 User Manual

1–26 MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
INTRODUCTION CHAPTER 1: INTRODUCTION
Z Select the switch to upgrade. Ensure you have system
administration privileges available on the switch.
Z Open a EnerVista Secure Web Management software session with
the switch by typing in the following URL:
https://<IP address of the switch>
If using FTP, save the configuration before proceeding. GE Multilin recommends a two-step
update: first save the configuration to the ftp server, then load the new image and restart
the switch (refer to Saving Configuration on page 5–19 for details on saving the
configuration).
Z Load the new firmware as shown below.
As the file is being loaded, the firmware will display the transfer in progress window.
Z Reboot the switch when the transfer is complete.
After reboot, the firmware is ready for use.
Z If using TFTP, save the configuration before proceeding.
GE Multilin recommends a two-step update:
• first save the configuration to the TFTP server,
• then load the new image and restart the switch (refer to Saving
Configuration on page 5–19 for details on saving the
configuration).

GE MultiLink ML1600 Specifications

General

Brand	GE
Model	MultiLink ML1600
Category	Switch
Language	English