Installation Instructions
[] REPLACING THE REFRIGERATOR DOORS
(cont.)
rD-] Insertthe top hinge pin into the hinge hole on top ofthe
refrigerator door. Makesure the door is aligned with the
cabinet and opposite door.Attach the hingeto the top
of the cabinet. Donot tighten bolts completelg.
tt :
i i i
i._ i i
[] On left-hand doors, passthe wires and water line
through the top hinge pin.Thenconnect the water line
and door electrical connector.
(
FF1 Attach the ground wire with a Phillips-headscrewdriver
at the right and left hinge.
[] Makesurethe gasket on the door is flush against
the cabinet and is not folded. Makesurethe door is
straight and the gap between the doors iseven across
the front. Whileholding the aligned door in place,
tighten the top hinge bolts.
rill Reconnectthe two pairs of connectors at the left and
the one pair of connectors at the right sideof the top
cap. Reattachthe three Phillips-headscrews on top.
Ground
Wire
[] REMOVE THE FREEZERDOOR
_'1 Pullthe freezer door open to fullextension.
[] Removethe freezerbin bg pulling both brackets upward
at the same time. (Seepage 19.)
Fc1 Takeout the lower basket bg liftingthe basket up from
the rail sgstem.(Seepage 19.)
[] Removethe two 10 mm hex-head boltsfrom the right
and left side.
29
To Next Page
Loading...
