ā 43 ā
To remove the DRM 1 on PS978:
1. Remove the rear cover. (See Rear Cover.)
Note: In the following step, do not remove the
orange relay jumper wire.
2. Disconnect the wire harnesses and mark and
disconnect wires that connect DRM 1 to the
range.
3. Compress the tab on each of the 4 compression
pins that attach DRM 1 to the range.
4. Transfer the relay jumper wires to the
replacement DRM 1.
Jumper Wire
To remove the DRM 2 on PS978:
1. Remove the rear cover. (See Rear Cover.)
2. Disconnect the wire harness and mark and
disconnect wires that connect DRM 2 to the
range.
3. Compress the tab on each of the 4 compression
pins that attach DRM 2 to the range.
To Next Page
Loading...
